Low-temperature DeNOx catalyst for reducing ultrafine particle emission

Low-temperature DeNOx catalyst for reducing ultrafine particle emission
SCR pilot DeNOx reactor through on-site exhaust gas injection. Credit: Korea Institute of Science and Technology(KIST)

Recently, there has been growing demand for DeNOx catalysts that can treat nitrogen oxides (NOx) at low temperatures to increase energy efficiency when processing flue gas in industrial combustion facilities. NOx are emitted during the combustion of fossil fuels and are the leading cause of ultrafine particles (UFPs) formed via chemical reactions in the atmosphere.

However, existing catalysts have a problem of reduced durability due to the poisoning of the catalyst's active sites because of the formation of ammonium sulfate, when sulfur in reacts with reducing agent ammonia at a low temperature (<250 degrees Celsius). To address this, studies have attempted to weaken the oxidation ability of sulfur oxide on the catalyst surface or delay the poisoning by limiting the reactivity of sulfur compounds; however, these solutions cannot increase the durability against sulfur.

At the Extreme Materials Research Center, part of the Korea Institute of Science and Technology(KIST), a research team of Dr. Kwon, Dong Wook and Dr. Ha, Heon Phil announced the development of a high-durability low-temperature catalyst material for selective catalytic reduction (SCR); it can reduce NOx into water and nitrogen, which are harmless to the environment and the human body.

The team successfully developed a composite vanadium oxide-based catalyst material that significantly limited the formation of poisonous ammonium sulfate by suppressing the adsorption reaction between the and sulfur dioxide. A catalyst interface engineering technique was used in which molybdenum and antimony oxide were added to the vanadium-based catalyst.

The developed vanadium oxide-based composite catalyst material has significantly increased catalytic life when exposed to sulfur dioxide at 220 degrees Celsius, with the time to reach 85% of the initial performance delayed by about seven times compared to that in the conventional catalyst. The developed catalyst is also energetically efficient due to increased low-temperature activity, which significantly lowers the burden of NOx treatment without reheating the exhaust gas. As a result, it is possible to reduce air pollutant treatment costs if the developed is applied to industrial sites in the future.

After completing the laboratory-scale reactor experiment, the team installed a pilot demonstration facility at the Kumho Petrochemical's Yeosu 2nd Energy Cogeneration Power Plant to test using actual flue gas. The KIST-Kumho Petrochemical team aims to establish plant facilities by 2022 after deriving an optimal operation plan by evaluating and verifying the driving variables of the demonstration facility for about ten months.

Ko, Young Hoon, the head of R&BD center of Kumho Petrochemical (Vice-President), mentioned, "Reducing NOx, which accounts for most of the harmful substances in the exhaust gas of our Cogeneration Power Plant, is a critical issue for Kumho Petrochemical's ESG management. We are successfully conducting empirical research by installing pilot equipment for power plants to secure preemptive reduction technology above the level of advanced countries, and we plan to conduct scale-up test of the technology in order to transform it to a high-durability low-temperature SCR catalytic commercial technology."

More information: Dong Wook Kwon et al, New insight into the role of Mo–Sb addition towards VMoSbTi catalysts with enhanced activity for selective catalytic reduction with NH3, Chemical Engineering Journal (2021). DOI: 10.1016/j.cej.2021.132078

Provided by National Research Council of Science & Technology

Citation: Low-temperature DeNOx catalyst for reducing ultrafine particle emission (2022, January 17) retrieved 29 March 2024 from https://phys.org/news/2022-01-low-temperature-denox-catalyst-ultrafine-particle.html
This document is subject to copyright. Apart from any fair dealing for the purpose of private study or research, no part may be reproduced without the written permission. The content is provided for information purposes only.

Explore further

For sustainable sulfur-tolerant catalysts, alloy precious metals with phosphorus

50 shares

Feedback to editors